grand cherokee RSS

Paul invited us over to help him with the Trail Forged High Clearance Front Bumper DIY Kit and asked if I wanted to record the process! I said Yes! Paul had already welded up most of the items and we were able to start getting the Winch mount and Radiator Skid Plate on. We had to cut off the center section core support area. USE A SAWZALL with a new blade! Less is more when cutting. The Install was not a hard one to do but it is time consuming. The welding according to Paul is not hard either as...

We finally have a winch mounted on my Jeep WJ Sort of. This winch is from OPENROAD and it is the Panther Series S2 model which is a 13,000LBS winch IP-67 Waterproof which is definitely needed for offroading. Recovery Gear when offroading is crucial because you will get stuck at some point or have a friend get stuck and you need to pull them out. I do have a Kinetic rope which is amazing for pulling but having a winch is also great because you can self recover or use the Jeep as an anchor and have the winch do...

So my Crankshaft Position Sensor went out on my Jeep Again! Big Tip: Don't buy cheap CPS Sensors and Replace the Cam Shaft Position Sensor at the same time. The Cam shaft sensor is easy to replace. If you are going to replace these sensors use Mopar sensors. They might be hard to find so I Used Standard from oriellys since from my research they are close to OEM Spec. The Crankshaft sensor is hard to remove from the hole and put back in but it is possible! Take the air intake off to give yourself more room and make...

I met David by trying to buy some Jeep parts off Craiglist haha. He pulled up in his Jeep WJ Grand Cherokee so I had to Record it! First thing you notice is the Awesome Bright Orange Paint Job! David Built his own front bumper and roof rack which both look amazing! Under the Jeep he has a ton of Goodies! Some of the parts include Iron rock front and rear long arms, IRO Hack 'n Tap Slip Yoke Eliminator Kit, IRO WJ Unibody Frame Stiffeners (Center Section), Gladiator Fox Shock Take offs, JKS Disconnects, and a 242HD Transfer case...

Chris and I rode our motorcycles down to San Diego to pick up an A-arm spacer for Chris' Jeep. While we were picking up the part from Dennis he showed us his Jeep! Luckily I had my Canon M50 and we were able to get a showcase on his Jeep! Dennis has a 2004 Jeep Grand Cherokee Overland with the 4.7HO Motor and only 118,000 miles! That is a Unicorn in my book! He added the Iron Rock Offroad Rock-Link Pro 4 inch lift kit. The long arms from Iron Rock are amazing and bolt on which is nice! He then...